Aerio L4-2.3L (2006)
8. Route deployment harness (1) out of vehicle.
9. Verify that inside of vehicle and area surrounding vehicle are clear of all people and loose or flammable objects.
10. Stretch deployment harness (1) to its full length 10 m (33 ft).
11. Place 12 volts vehicle battery (2) near shorted end of deployment harness (1).
12. Completely cover windshield area and front door window openings with drop cloth, a blanket or any similar item (3). This reduces possibility of
injury due to possible fragmentation of vehicle s glass or interior.
13. Notify all people in immediate area that you intend to deploy air bag (inflator) module or activate seat belt pretensioner.
NOTE:
-
When air bag (inflator) module deploys or seat belt pretensioner activates, rapid gas expansion will create substantial report. Wear suitable ear
protection. Notify all people in immediate area that you intend to deploy air bag (inflator) module or to activate seat belt pretensioner and suitable
ear protection should be worn.
-
After air bag (inflator) module has been deployed, surface of air bag may contain powdery residue. This powder consists primarily of cornstarch
(used to lubricate air bag (inflator) module as it inflates) and by-products of chemical reaction.
WARNING:
-
Do not place deployed air bag (inflator) module and activated seat belt pretensioner near any flammable objects.
-
Do not apply water, oil, etc. to deployed air bag (inflator) module and activated seat belt pretensioner.
-
Wait for about 30 minutes before touching any metal surface of air bag (inflater) module or seat belt pretensioner module.
Disregarding these precautions may cause fire or personal injury. Failure to follow procedures may result in fire or personal injury.
14. Separate two banana plugs (1) on deployment harness (2).
15. Connect deployment harness (2) to 12 volts vehicle battery (3). This will immediately deploy or activate air bag (inflator) module or seat belt
pretensioner.
16. Disconnect deployment harness (2) from 12 volts vehicle battery (3) and short two deployment harness leads together by fully seating one banana
plug into the other.
17. Repeat Steps 2) through 16) to deploy / activate air bag (inflator) modules and seat belt pretensioners which has not been deployed / activated, if
any.
18. In the unlikely event that air bag (inflator) module and seat belt pretensioner after following these procedures, proceed immediately with Step 24)
through 26). If air bag (inflator) module and seat belt pretensioner did deploy / activate, proceed with Steps 19) through 23).
19. Carefully remove drop cloth from vehicle and clean off any fragments or discard it entirely.
20. Put on pair of shop gloves to protect your hands from possible irritation and heat when handling deployed air bag (inflator) module and activated
seat belt pretensioner.
