Aerio L4-2.3L (2006)
Impact Sensor: Testing and Inspection
With Advanced Air Bag
Forward Sensor Inspection
Forward Sensor Inspection
Reference: Forward Sensor Removal and Installation:Advanced Air Bag
WARNING:
During service procedures, be very careful when handling a sensor.
-
Never strike or jar a sensor.
-
Under some circumstances, it could cause improper operation of the air bag system. A sensor and mounting bracket bolts must be
carefully torqued to assure proper operation.
CAUTION:
-
Never disassemble forward sensor.
-
Sensor should be replaced when it was dropped from a height of 90 cm (3 ft) or more.
-
Check sensor for dents, cracks or deformation.
-
Check sensor connector (sensor side and harness side) and sensor connector lock mechanism for damage or crack.
-
Check connector terminals for bend, corrosion or rust.
Side Sensor Inspection
Side Sensor Inspection
CAUTION:
-
Never disassemble side sensor.
-
Sensor should be replaced when it was dropped from a height of 90 cm (3 ft) or more.
-
Check sensor (1) for dents, crack, deformation.
-
Check sensor connector (sensor side and harness side), lock mechanism or sensor lead wire for damage, crack, scorching or melting.
-
Check connector terminals for bent, corrosion or rust. If any faulty condition is found in above checks, replace.
