Equator 2WD V6-4.0L (2009)
Air Bag: Service and Repair
Driver Air Bag Module
Driver Air Bag Module: Removal and Installation
REMOVAL
CAUTION:
-
Do not attempt to repair or replace damaged direct-connect SRS component connectors. If a driver air bag direct-connect harness
connector is damaged, the spiral cable must be replaced.
-
Before servicing the SRS, turn ignition switch OFF, disconnect both battery terminals and wait at least three minutes.
-
When servicing the SRS, do not work from directly in front of air bag module.
1. Disconnect the negative and positive battery terminals, then wait at least three minutes.
2. Locate retaining clip access hole and insert suitable 4mm - 6mm blunt tool.
NOTE: Do not use sharp edged objects such as screwdrivers to release driver air bag module from steering wheel, SRS components may be
unintentionally damaged.
3. Press upward (toward center of steering wheel) on retaining clip until driver air bag module is released from steering wheel.
4. Lift the driver air bag module from the steering wheel.
5. Disconnect the driver air bag module and horn connectors, then remove the driver air bag module.
-
For removal/installation of the direct-connect SRS connectors, refer to [Direct connect SRS Component Connectors Description].
CAUTION:
-
When servicing the SRS, do not work from directly in front of air bag module.
-
Always place air bag module with pad side facing upward.
