Esteem L4-1590cc 1.6L SOHC 0 MFI 16V (1995)
3. Using journal diameter measured above and alphabets stamped on mating surface of cylinder block, select an undersize bearing by referring to
table given below. Check bearing clearance with newly selected undersize bearing.
REAR OIL SEAL
Carefully inspect oil seal for wear or damage. If its lip is worn or damaged, replace it.
For oil seal installation, press-fit rear oil seal so that oil seal housing end face is flush with oil seal end face.
FLYWHEEL
-
If ring gear is damaged, cracked or worn, replace flywheel.
-
If the surface contacting clutch disc is damaged, or excessively worn, replace flywheel.
-
Check flywheel for face runout with dial gauge. If runout exceeds its limit, replace flywheel.
Limit on runout: 0.2 mm (0.0073 inch)