Esteem L4-1590cc 1.6L SOHC 0 MFI 16V (1995)
Input Shaft: Service and Repair
DISASSEMBLY
1. Remove input shaft R bearing by using bearing puller and press.
2. Drive out 5th gear spacer, L bearing and 4th gear all at once by using puller and press.
CAUTION:
^
To avoid gear tooth from being damaged, support it at flat side of bearing puller.
^
Stop press work in the middle way and take out 5th gear bush to prevent it from being compressed and then continue to remove bearing with
gear.
3. Take out 4th gear needle bearing and high speed synchronizer ring.
4. Using Special Tool (A): 09900-06107, or equivalent, remove circlip.
NOTE: For smooth removal of circlip, it is recommended to correct tool tips to be flat.
5. Drive out high speed synchronizer sleeve & hub assembly together with 3rd gear by using puller and press.
CAUTION: Make sure to use flat side of puller to avoid causing damage to 3rd gear tooth.