suzuki Workshop Repair Guides

Suzuki Workshop Service and Repair Manuals

Fluid - A/T|Capacity Specifications|Page 2048 > < Fluid - A/T|Capacity Specifications|Page 2046
Page 2
background image

7. Pull out dipstick again and check fluid level indicated on it. Fluid level should be between FULL HOT and LOW HOT. If it is below LOW HOT,

and an equivalent of DEXRON(R)-III up to FULL HOT.
Fluid specification:

An equivalent of DEXRON(R)-III

NOTE:  
^

DO NOT RACE ENGINE while checking fluid level, even after the engine start.

^

DO NOT OVERFILL. Overfilling can cause foaming and loss of fluid through breather. Then slippage and transmission failure can result.

^

Bringing the level from LOW HOT to FULL HOT requires 0.4 liters (0.85 / 0.70 US / Imp. pt).

^

If vehicle was driven under high load such as pulling a trailer, fluid level should be checked about half an hour after it is stopped.

Fluid - A/T|Capacity Specifications|Page 2048 > < Fluid - A/T|Capacity Specifications|Page 2046