Forenza L4-2.0L (2004)
2. Install the starter mounting bolts.
Tighten: Tighten the starter-to-engine block mounting bolt to 45 Nm (33 ft. lbs.) and the starter-to-engine transaxle mounting bolt to 50 Nm (37
ft. lbs.).
3. Position the starter electrical wire on the solenoid terminals and the ground wire on the lower stud.
4. Install the starter solenoid nuts and the ground wire nut.
Tighten:
Tighten the starter solenoid terminal-to-battery cable terminal nut to 12 Nm (106 in. lbs.), and the starter solenoid terminal-to-ignition solenoid
terminal nut to 6 Nm (53 in. lbs.).
Tighten the starter lower mounting stud ground wire nut to 12 Nm (106 in. lbs.).
