Grand Vitara LTD 2WD V6-2.5L (2001)
NOTE:
^
Make sure that nut (4) and cable joint (3) have clearance under above conditions.
^
If select cable (1) has been moved, push it in arrow C direction as shown in figure at the left till it stops and then confirm that select lever is in
"N" position.
3. Turn nut (3) by hand till it contacts manual select cable joint (2). Then tighten nut (4) with wrench.
4. After select cable (1) was installed, check for the following.
^
Push vehicle with select lever shifted to "P".
^
Vehicle should not move.
^
Vehicle can not be driven in "N".
^
Vehicle can be driven in "D", "2", and "L".
^
Vehicle can be backed in "R".
