Kizashi AWD L4-2.4L (2010)
9) When depressing brake pedal up to special tool gauge reading 10 MPa (102 kgf/cm2, 1450 psi), check "Master Cyl Press" under "DATA LIST" of
SUZUKI scan tool.
If check result displayed on SUZUKI scan tool is not as specified, replace ESP(R) hydraulic unit / control module assembly.
Master cylinder pressure specification
Brake pedal depressed 10 MPa (102.0 kgf/cm2, 1450 psi): 10 ± 1.2 MPa (102 ± 12.2 kgf/cm2, 1450 ± 174 psi)
10) After completing the check, push engine switch to change ignition mode of keyless push start system to "OFF" and disconnect SUZUKI scan tool
from DLC.
11) Remove special tool, tighten bleeder plug and bleed air from brake system.
12) Check Check brake fluid level in master cylinder reservoir.
