Reno L4-2.0L (2006)
Alternator: Removal and Replacement
Generator Removal and Installation
Removal
1. Disconnect the negative battery cable.
2. Disconnect the manifold air temperature (MAT) sensor electrical connector the air intake tube.
3. Remove all the clamps from the air cleaner outlet hose, and set aside the tube.
4. Raise and suitably support the vehicle.
5. Disconnect the harness connector from the back of the generator, and the generator lead to the battery.
6. Remove the serpentine accessory drive belt by lowering the vehicle and turning the automatic tensioner roller bolt clockwise to relieve tension on
the belt. Refer to Serpentine Accessory Drive Belt Removal and Installation.
7. Push up the power steering reservoir and set it aside.
