Sidekick 4 Door 4WD L4-1.8L DOHC MFI 16V (1996)
passenger's compartment.
8.
Plug the red wire male connector into the red wire female connector on the main control unit wiring harness.
9.
Re-install the glove box and speaker cover.
G. Impact Sensor
G.
Impact Sensor
(1994-1995 vehicles: p/n 99980-46060-007; 1996 vehicles: p/n 99980-46061-007)
1.
Remove the RH speaker cover and Glove Box Pivot Pin.
2.
Remove the glove box from the passenger's side dash.
3.
Locate and disconnect the yellow and the brown/black bullet connectors in the main wiring harness.
4.
Locate the sensor under the hood on the firewall. From the engine compartment, pull the yellow and the brown/black wires through the
grommet in the firewall.
5.
Disconnect the sensor's black ground wire from the bolt on the siren.
6.
Remove the sensor from the bracket.
7.
Place the new sensor back in the same position on the bracket.
8.
Connect the black ground wire to the bolt on the siren.
9.
Push the yellow wire and the brown/black wire through the grommet in the firewall. From inside the vehicle, pull the excess wire into the
passenger's compartment.
10.
Connect the yellow male connector and the brown/black male connector into the female connectors on the main wiring harness.
11.
Re-install the glove box and speaker cover.
12.
Remove the rubber covers on the impact sensor. Using a small Phillips head screw driver, test and adjust the sensor's sensitivity to a desired
setting. When finished, reinstall the rubber covers onto the sensor.
Component/Connector Identification and Location
1994-1995 Sidekick 2-door and 4-door
