suzuki Workshop Repair Guides

Suzuki Workshop Service and Repair Manuals

Rear Case|Page 1652 > < Rear Case|Page 1650
Page 2
background image

3. Check gear shift shaft for excessive wear and correct or replace a necessary.

4. Check free length of each locating spring and replace if it is below service limit.

Free length "b":

Standard: 27.0 mm (1.063 inch) 
Service limit: 24.0 mm (0.945 inch) 

ASSEMBLY

Interlock system is as shown in the figure. Assemble its parts according to procedure as described.

1. With fork installed to reverse gear shift shaft, install it into case and put in interlock ball.

Rear Case|Page 1652 > < Rear Case|Page 1650