Swift L4-1298cc 1.3L SOHC MFI (1997)
9. Check toe setting. Adjust as required.
10. Tighten both tie rod end lock nuts to specified torque.
Tightening Torque (d): 35 - 55 Nm (25.5 - 39.5 ft. lbs.)
Rack Plunger
REMOVAL
1. Remove rack boots and tie rods.
2. Remove parts as shown.
INSTALLATION
1. Apply grease lightly to sliding part of plunger against rack.
2. Install parts as shown.
3. Apply sealant to all around thread part of rack damper screw and tighten to specified torque.
"A": Sealant 99000-31110 or equivalent.
Tightening Torque (a): 15 Nm (10.8 ft. lbs.)