Swift GA L4-1298cc 1.3L SOHC MFI (2001)
8. Remove wheel stud bolt by using hydraulic press.
9. Insert new stud in drum hole and rotate it slowly to assure serrations are aligned with those made by replaced bolt.
INSTALLATION
WARNING: All brake fasteners are important attaching parts in that they could affect the performance of vital parts and systems, and/or
could result in major repair expense. They must be replaced with ones of same part number or with an equivalent part if replacement
becomes necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during
reassembly to assure proper retention of all parts. There is to be no welding as it may result in extensive damage and weakening of the metal.
1. Before installing brake drum, to maximize brake shoe-to-drum clearance, put screwdriver between rod and ratchet and push down ratchet.
NOTE: Left figure shows ratchet position where brake shoe-to-drum clearance is maximum.
2. Put brake shoe lever stopper back to its original position. (Put shoe lever stopper in place by moving shoe lever so that shoe lever is held at its
original position.)
