Swift GA L4-1298cc 1.3L SOHC MFI (2001)
3. Install brake drum after making sure that inside of brake drum and brake shoes are free from dirt and oil. 4) Install washer and new spindle nut. 5)
Tighten spindle nut to specified torque.
Tightening Torque (a): 100 Nm (10.0 kg-m, 72.5 ft. lbs.)
NOTE: Removed spindle nut should be replaced with new one.
6. Caulk spindle nut.
7. Install spindle cap.
NOTE:
^
When installing spindle cap, hammer lightly several locations on the collar of cap until collar comes closely into contact with brake drum.
^
If fitting part of cap is deformed or damaged or if it is fitted loosely, replace with new one.
8. Upon completion of all jobs, depress brake pedal with about 30 kg (66 lbs.) load three to five times so as to obtain proper drum-to-shoe clearance.
Adjust parking brake cable.
9. Install parking brake lever cover.
10. Install wheel and tighten wheel nuts so specified torque.
Tightening Torque (b): 65 Nm (6.5 kg-m, 47.0 ft. lbs.)
11. Check to ensure that brake drum is free from dragging and proper braking is obtained. Then remove car from hoist and perform brake test (foot
brake and parking brake).
