Swift GA L4-1298cc 1.3L SOHC MFI (2001)
Brush Holder: Testing and Inspection
0.9 KW Conventional Type
BRUSH HOLDER AND SPRING
-
Check movement of brush in brush holder. If brush movement within brush holder is sluggish, check brush holder for distortion and sliding faces
for contamination.
Clean or correct as necessary.
Check for continuity across insulated brush holder (positive side) and grounded brush holder (negative side).
If continuity exists, brush holder is grounded due to defective insulation and should be replaced.
-
Inspect brush spring for wear, damage or other abnormal conditions. Replace if necessary.
Brush spring tension
Standard: 1.95 kg (4.3 lb.)
Limit : 0.9 kg (1.98 lb.)