Swift GL L4-1298cc 1.3L SOHC MFI (2000)
7. Tighten spindle nut to specified torque.
NOTE: Removed spindle nut should be replaced with new one.
Tightening Torque (a): 175 Nm (17.5 kg.m, 126.5 ft. lbs.)
8. Calk spindle nut as shown.
9. Install spindle cap.
NOTE:
^
When installing spindle cap, hammer lightly several locations on the collar of cap until collar comes closely into contact with brake drum.
^
If fitting part of cap is deformed or damaged or if it is fitted loosely, replace with new one.
10. For procedure hereafter, refer to steps 6) to 12) of wheel cylinder INSTALLATION.
