Swift GL L4-1298cc 1.3L SOHC MFI (2000)
10. Using special tool, tighten pulley bolt to specified torque.
Tightening Torque (a): 60 Nm (6.0 kg-m, 43.5 ft. lbs.)
Special Tool
(A): 09917-68220
11. Install belt tensioner, timing belt, outside cover, crankshaft pulley and water pump belt as previously outlined.
12. After applying sealant to part "A" as shown in figure at the left, install CMP sensor case (Distributor less ignition coil case) to cylinder head and
tighten its fixing bolts to specified torque.
"A" Sealant: 99000-31110
Tightening Torque (a): 11 Nm (1.1 kg-m, 8.0 ft. lbs.)
13. Adjust valve clearance as previously outlined.
14. Install cylinder head cover and air cleaner outlet hose.
15. Check to ensure that following parts are back in place:
^
Ignition coil assemblies
^
High tension cords
^
CMP sensor coupler
^
Couplers to ignition coil assembly
^
Other removed parts which have not been reinstalled
16. Connect negative cable at battery.
17. Confirm that ignition timing is within specification. Refer to Ignition System; Ignition Timing.
