SX4 4WD L4-2.0L (2008)
Yaw Rate Sensor: Service and Repair
Yaw Rate / G Sensor Assembly Removal and Installation
Yaw Rate / G Sensor Assembly Removal and Installation
CAUTION:
^
Regarding yaw rate / G sensor assembly removal/ installation, confirm specified torque and never use impact wrench to avoid damage.
^
When handling the yaw rate / G sensor assembly, be careful not to drop it or apply an impact to it. If an excessive impact was applied,
never attempt disassembly or repair but replace it with a new one.
Removal
1. Disconnect negative (-) cable at battery.
2. Remove console box.
3. Disconnect connector from yaw rate / G sensor assembly.
4. Remove yaw rate G sensor assembly from sensor bracket.
Installation
1. Before installing yaw rate / G sensor assembly (1), check installing condition as follows.
^
Deformations around sensor installation area (2) (in sensor bracket).
^
Foreign matters on mating surface between sensor and sensor bracket.
2. Install yaw rate / G sensor assembly (1) to floor panel.
Tightening torque
Yaw rate / G sensor assembly bolt a: 6.5 Nm (0.65 kgf-m, 5.0 ft. lbs.)
