XL-7 Touring 4WD V6-2.7L (2002)
A: Without ABS B: With ABS
5a. Apply grease "A" to axle shaft inner oil seal lip as shown in the figure.
"A": Grease 99000-25010
5b. Apply water tight sealant "B" to mating surface of brake back plate and rear axle hub (2).
"B": Sealant 99000-31110
6. Install rear axle shaft to rear axle housing and tighten bearing retainer nuts to specified torque.
Rear axle shaft length "L"
Left side: 700.5 mm (27.6 inch)
Right side: 769.5 mm (30.3 inch)
NOTE: When installing rear axle shaft, be careful not to cause damage to oil seal lip in axle housing.
Tightening torque
Bearing retainer nut (a): 50 Nm (5.0 kgf-m, 36.5 ft. lbs.)
