Avalon XL V6-3.0L (1MZ-FE) (1997)
Connecting Rod: Service and Repair
Disassembly
1. Disconnect connecting rod from piston.
(a)
Using a small screwdriver, pry out the 2 snap rings.
(b) Gradually heat the piston to approximately 60° C (140° F).
(c)
Using a plastic-faced hammer and brass bar, lightly tap out the piston pin and remove the connecting rod.
NOTE:
^
The piston and pin are a matched set.
^
Arrange the pistons, pins, rings, connecting rods and bearings in the correct order.