Camry L4-2.4L (2AZ-FE) (2005)
/Page-375007.png)
b) Put a bar ([diameter] 4 mm (0.16 inch)) in the adjusting hole of the oil pump driven sprocket to temporarily lock the sprocket in position.
Remove the nut.
c) Remove the bolt, chain tensioner plate and spring.
d) Remove the chain tensioner, oil pump driven sprocket and chain.
36. INSTALL NO.2 CHAIN SUB-ASSEMBLY
a) Set the crankshaft key into the left horizontal position.
b) Turn the cutout of the oil pump drive shaft to the top.
c) Align the mark links (yellow colored links) with the timing marks of the sprocket as shown in the illustration.
d) Insert the sprockets with chain to the crankshaft and oil pump shaft.
e) Temporarily tighten the oil pump driven sprocket with the nut.
