Camry V6-3.3L (3MZ-FE) (2005)
2. REMOVE FRONT STABILIZER LINK ASSEMBLY LH
a. Remove the 2 nuts and front stabilizer link assembly LH.
HINT: If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.
3. REMOVE FRONT STABILIZER LINK ASSEMBLY RH
HINT: Remove the RH side following the same procedures as with the LH side.
4. REMOVE FRONT STABILIZER BRACKET NO.1 LH
a. Remove the 2 bolts and front stabilizer bracket No. 1 LH.
5. REMOVE FRONT STABILIZER BRACKET NO.1 RH
HINT: Remove the RH side by the same procedures with the LH side.
6. DISCONNECT TIE ROD END SUB-ASSEMBLY LH
SST 09628-62011
7. DISCONNECT TIE ROD END SUB-ASSEMBLY RH
SST 09628-62011
HINT: Disconnect the RH side by the same procedures with the LH side.
8. DISCONNECT STEERING GEAR OUTLET RETURN TUBE
SST 09023-00100
9. DISCONNECT PRESSURE FEED TUBE ASSEMBLY
SST 09023-00100
10. DISCONNECT STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY
11. REMOVE POWER STEERING GEAR ASSEMBLY
12. REMOVE STABILIZER BAR FRONT
a. Remove the stabilizer bar front from the vehicle.
13. REMOVE FRONT STABILIZER BAR BUSH NO.1
a. Remove the 2 bushes from the stabilizer.
14. INSPECT FRONT STABILIZER LINK ASSEMBLY LH