Camry V6-3.5L (2GR-FE) (2008)
(e) Install the front flexible hose and front speed sensor wire harness with the bolt.
Torque: 19 Nm (194 kgf-cm, 14 ft-lbf)
NOTE: Do not twist the front speed sensor wire harness when installing it.
(f) Fully tighten the lock nut.
Torque: 70 Nm (714 kgf-cm, 52 ft-lbf)
2. INSTALL FRONT STABILIZER LINK ASSEMBLY
(a) Install the front stabilizer link assembly with the nut.
Torque: 74 Nm (755 kgf-cm, 55 ft-lbf)
HINT: If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud.
3. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
4. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(See: Alignment/Service and Repair/Front Wheel Alignment)
Disposal
SUSPENSION: FRONT SHOCK ABSORBER:
DISPOSAL
1. DISPOSE OF FRONT SHOCK ABSORBER
(a) Fully extend the shock absorber rod.
(b) Using a drill, make a hole in the cylinder between A and B as shown in the illustration to discharge the gas inside.
CAUTION:
-
Be careful when drilling because shards of metal may fly about. Always use the proper safety equipment.
-
The gas is colorless, odorless and non-poisonous.