Camry CE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
2. Inspect front shock absorber.
a. Compress and extend the shock absorber rod.
b. Check that there is no abnormal resistance or unusual operation sounds.
3. Dispose of front shock absorber, if needed.
a. Fully extend shock absorber rod.
b. Drill hole to remove gas from cylinder.
CAUTION:
-
Drill a hole between the lines, as shown in image.
-
The gas coming out is harmless, but be careful of chips which may fly up when drilling.
Assembly
1. Install lower insulator onto shock absorber.
2. Install spring bumper to piston rod.
3. Install coil spring.
a. Using Special Service Tool (SST) 09727 - 30021, compress the coil spring.
CAUTION: Do not use an impact wrench. It will damage the SST.
NOTE: Use 2 of the same type of SST.
b. Install the coil spring to the shock absorber.
NOTE: Fit the lower end of the coil spring into the gap of the spring lower seat.
4. Install spring upper seat and insulator.
