Camry LE Sedan V6-3.0L (1MZ-FE) (1998)
Clutch Pedal Assembly: Testing and Inspection
INSPECTION
1. CHECK THAT PEDAL HEIGHT IS CORRECT
Pedal height from asphalt sheet:
1MZ-FE: 161.8 - 171.8 mm (6.370 - 6.764 inch)
5S-FE: 156.8 - 166.8 mm (6.173 -6.567 inch)
2. IF NECESSARY, ADJUST PEDAL HEIGHT
Loosen the lock nut and turn the stopper bolt until the height is correct. Tighten the lock nut.
3. CHECK THAT PEDAL FREEPLAY AND PUSH ROD PLAY ARE CORRECT
Push in on the pedal until the beginning of clutch resistance is felt.
Pedal freeplay: 5.0 - 15.0 mm (0.197 - 0.591 inch)
Gently push the pedal until the resistance begins to increase a little.
Push rod play at pedal top: 1.0 - 5.0 mm (0.039 - 0.197 inch)
4. IF NECESSARY, ADJUST PEDAL FREEPLAY AND PUSH ROD PLAY
a. Loosen the lock nut and turn the push rod until the freeplay and push rod play are correct.
b. Tighten the lock nut.
c. After adjusting the pedal freeplay, check the pedal height.
d. Connect the air duct and install the lower finish panel.