Camry Sedan 4-Door V6-3.0L (1MZ-FE) (1994)
Variable Induction Control Valve: Service and Repair
PROCEDURE
Removal
1. Disconnect negative (-) terminal cable from battery.
CAUTION: Work must be started after 90 seconds from the time the ignition switch is turned to the LOCK position and the negative (-) terminal
cable is disconnected from the battery.
2. Disconnect hoses from Intake Air Control Valve.
^
Disconnect the following:
-
Brake booster vacuum hose. (1)
-
A/C idle-up air hose. (2)
-
Actuator vacuum hose. (3)
-
Disconnect the Data Link Connector 1. (b)
3. Remove Intake Air Control Valve.
^
Remove the 4 nuts and Data Link Connector 1 bracket, and disconnect the 2 ground straps.
^
Remove the Intake Air Control Valve by GENTLY prying a screwdriver between the Intake Air Control Valve and Air Intake Chamber.
^
Remove the gasket.
Installation
1. Install Intake Air Control Valve.