Camry XLE Sedan L4-2164cc 2.2L DOHC (5S-FE) MFI (1999)
_mfi/Page-517001.png)
Drive Belt: Testing and Inspection
Power Steering
INSPECTION:
1. INSPECT DRIVE BELT
a. Visually check the belt for excessive wear, frayed cords etc.
If any defect has been found, replace the drive belt.
HINT: Cracks on the rib side of a belt are considered acceptable. If the belt has chunks missing from the ribs, it should be replaced.
b. Using a belt tension gauge, measure the belt tension.
Belt tension gauge:
DENSO BTG-20 (95506-00020)
Borroughs No.BT-33-73F
5S-FE Engine:
Drive belt tension:
New belt: 95 - 145 lbs.
Used belt: 60 - 100 lbs.
1MZ-FE Engine:
Drive belt tension:
New belt: 150 - 185 lbs.
Used belt: 95 - 135 lbs.
If the belt tension is not as specified, adjust it.
HINT:
^
"New belt" refers to a belt which has been used less than 5 minutes on a running engine.
^
"Used belt" refers to a belt which has been used on a running engine for 5 minutes or more.
^
After installing a belt, check that it fits properly in the ribbed grooves.
^
Check with your hand to confirm that the belt has not slipped out of the groove on the bottom of the pulley.
