Celica L4-1.8L (2ZZ-GE) (2005)
/Page-611007.png)
(1) Using a pin punch and hammer, install the straight pin into the center bearing case.
(2) Using SST and a press, install a new center bearing into the bearing case.
SST 09950-60010 (09951-00650), 09950-70010 (09951-07150)
(3) Using a screwdriver, install a new outside snap ring.
(4) Using SST and a press, install the center bearing with the bearing case assembly to the inboard joint shaft.
SST 09710-30021 (09710-03141)
(5) Using a snap ring expander, install a new inside snap ring.
(6) Using SST, an extension bar and press, install a new dust cover.
SST 09506-35010
HINT: The clearance between the dust cover and bearing should be kept in the ranges as shown in the illustration.
