Celica L4-1.8L (2ZZ-GE) (2005)
(1) Using a screwdriver, remove the outside snap ring.
(2) Using a press, remove the center bearing case.
(3) Using a pin punch and hammer, remove the straight pin from the center bearing case.
(4) Using SST and a press, remove the dust cover.
SST 09950-00020
(5) Using a snap ring expander, remove the inside snap ring.
(6) Using a press, remove the center bearing.
REASSEMBLY
1. REASSEMBLE INBOARD JOINT SHAFT
a. LH: Install dust cover.
Using a press, install a new dust cover.
b. LH shaft of 1Z-FE engine (M/T) and 2ZZ-GE engine; Using a snap ring expander, install a new outer snap ring.
c. RH: Install center bearing.