Celica GT-S L4-1.8L (2ZZ-GE) (2000)
b. Apply seal packing to 2 locations as shown in the illustration.
Seal packing: Part No. 08826-00080 or equivalent
c. Install the gasket to the cylinder head cover.
HINT: Part must be assembled within 3 minutes of application. Otherwise the material must be remove and reapplied.
d. Install the cylinder head cover with the 9 bolts, 2 seal washers and 2 nuts.
Uniformly tighten the bolts and nuts, in the several passes, in the sequence shown.
Torque:
w/o washer: 11 Nm (113 kgf-cm, 8 ft. lbs.)
w/ washer: 9.0 Nm (92 kgf-cm, 80 inch lbs.)
e. Connect the 2 PCV hoses to the cylinder head cover.
f.
Install the ignition coil.
18. 2ZZ-GE: INSTALL CYLINDER HEAD COVER
a. Remove any old packing (FIPG) material.
HINT: When FIPG on the head cover gasket side cannot be eliminated completely, replace the gasket.
b. Apply seal packing to 2 locations as shown in the illustration.
Seal packing: Part No. 08826-00080 or equivalent
c. Install the gasket to the cylinder head cover.
HINT: Part must be assembled within 3 minutes of application. Otherwise the material must be remove and reapplied.