Celica GT Convertible L4-2164cc 2.2L DOHC MFI (1997)
15. Remove No. 1 timing belt cover.
(a)
Disconnect the crankshaft position sensor wire from the clamp on the timing belt cover.
(b) Disconnect the clamp of the crankshaft position sensor wire from the timing belt cover.
(c)
Remove the 4 bolts and timing belt cover.
16. Remove timing belt guide.
17. Remove timing belt.
NOTE (When re-using timing belt): Draw a direction arrow on the timing belt (in the direction of engine revolution), and place matchmarks on the
timing belt and crankshaft timing pulley.
18. Remove No. 1 idler pulley and tension spring.
Remove the bolt, pulley and tension spring.
19. Remove No. 2 idler pulley.
Remove the bolt and pulley.
20. Remove crankshaft timing pulley.
If the pulley cannot be removed by hand, use SST Puller C Set # 09950 - 50010 (Hanger 150 # 09951 - 05010, Slide Arm # 09952 - 05010, Center
Bolt 100 # 09953 - 05010, Center Bolt 150 # 09953 - 05020, Claw No. 2 # 09954 - 05020 for type A, Claw No. 1 # 09954 - 05010 for type B) or
equivalents to remove the timing pulley.
CAUTION: Do not scratch the angle sensor of the timing pulley.
