Celica GT Liftback L4-2164cc 2.2L DOHC (5S-FE) MFI (1999)
_mfi/Page-1312014.png)
14. INSTALL RACK HOUSING CAP LOCK NUT
a. Apply sealant to 2 or 3 threads of the nut.
Sealant: Part No.08833-00080, THREE BOND 1344, LOCTITE 242 or equivalent
b. Using SST, torque the nut.
SST 09922-10010
Torque: 50 Nm (513 kgf-cm, 37 ft. lbs.)
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
HINT: Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
15. INSTALL RACK GUIDE SEAT, RACK GUIDE, RACK GUIDE SPRING AND RACK GUIDE SPRING CAP
a. Install the seat to the guide.
b. Apply sealant to 2 or 3 threads of the cap.
Sealant: Part No.08833-00080, THREE BOND 1344, LOCTITE 242 or equivalent
c. Temporarily install the cap.
16. ADJUST TOTAL PRELOAD
a. To prevent the steering rack teeth from damaging the oil seal lip, temporarily install the RH and LH rack ends.
b. Using a hexagon wrench (24 mm), torque the rack guide spring cap.
Torque: 25 Nm (250 kgf-cm, 18 ft. lbs.)
c. Using a hexagon wrench (24 mm), return the cap 12°.
