Celica GT Liftback L4-2164cc 2.2L DOHC (5S-FE) MFI (1999)
d. Using SST, turn the control valve shaft right and left 1 or 2 times.
SST 09616-00010
e. Using a hexagon wrench (24 mm), loosen the cap until the rack guide spring is not functioning.
f.
Using SST, a torque wrench and hexagon wrench (24 mm), tighten the cap until the preload is within specification.
SST 09616-00010
Preload (turning): 1.2-1.5 Nm (12-15 kgf-cm, 10.4-13.0 inch lbs.)
17. INSTALL RACK GUIDE SPRING CAP LOCK NUT
a. Apply sealant to 2 or 3 threads of the nut.
Sealant: Part No.08833-00080, THREE BOND 1344, LOCTITE 242 or equivalent
b. Using a hexagon wrench (24 mm) to hold the rack guide spring cap and using SST, torque the nut.
SST 09922-10010
Torque: 50 Nm (513 kgf-cm, 37 ft. lbs.)
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
HINT: Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
c. Using SST and a torque wrench, recheck the total preload.
SST 09616-00010