Corolla L4-1.8L (2ZZ-GE) (2005)
c. Apply seal packing to 2 locations as shown in the illustration.
Seal packing: Part No.08826-00080 or equivalent
NOTICE:
-
Remove any oil from the contact surface.
-
Install the cylinder head cover within 3 minutes of applying seal packing.
-
Do not put into engine oil for at least 2 hours after installing.
d. Install the cylinder head cover, wire harness protector and bracket with the 9 bolts.Uniformly tighten the bolts, in the several passes in the
sequence shown.
Torque: 10 Nm (102 kgf-cm, 7 ft. lbs.)
e. Install the union to connector tube hose clamp with the bolt.
Torque: 7.0 Nm (71 kgf-cm, 62 inch lbs.)
f.
Install the fuel tube clamp with the bolt.
Torque: 7.5 Nm (76 kgf-cm, 66 inch lbs.)
g. Install the wire harness protector with the 2 nuts.
Torque: 9.0 Nm (92 kgf-cm, 80 inch lbs.)
h. Install a new gasket and ventilation tube No.1 with the 2 nuts and bolt.
Torque:
10 Nm (102 kgf-cm, 7 ft. lbs.) for nut
24 Nm (245 kgf-cm, 18 ft. lbs.) for bolt