Corolla L4-1.8L (2ZZ-GE) (2005)
b. Apply engine oil to the chain tensioner, then install it.
Torque: 9.0 Nm (92 kgf-cm, 80 inch lbs.)
NOTICE: When installing the tensioner, set the hook again if the hook releases the plunger.
c. Turn the crankshaft counterclockwise to disconnect the plunger knock pin from the hook.
d. Turn the crankshaft clockwise, then check that the slipper is pushed by the plunger.
HINT: If the plunger is not expended, push the slipper into the chain tensioner with a screwdriver so that the hook is released from the knock
pin and the plunger can be extended.
29. CHECK VALVE CLEARANCE
30. ADJUST VALVE CLEARANCE
SST 09248-77010 (09248-07010)
31. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY
a. Install a new O-ring onto the cylinder head cover.
b. Remove any old packing (FIPG) material.