Corolla L4-1.8L (2ZZ-GE) (2005)
1. REMOVE FRONT SUSPENSION BAR ASSEMBLY TOWER
a. Placing a wooden block in-between, support the front suspension lower arm sub-assembly No.1 LH and the front suspension lower arm
sub-assembly No.1 RH.
b. Remove the 6 nuts and then remove the front suspension bar assembly tower.
2. REMOVE TOWER BAR BRACKET SUB-ASSEMBLY LH
a. Remove the bolt and then remove the tower bar bracket sub-assembly LH from the front suspension bar assembly tower.
3. REMOVE TOWER BAR BRACKET SUB-ASSEMBLY RH
a. Remove the bolt and then remove the tower bar bracket sub-assembly RH from the front suspension bar assembly tower.
4. INSPECT FRONT SUSPENSION BAR ASSEMBLY TOWER
a. Cause the front suspension bar assembly tower to expand and contract 4 times or more. Check that there is no abnormal resistance/noise,
operational resistance, bends/scratches on the rod or oil leakage. If these are found, replace the front suspension bar assembly tower with a new
one.
NOTICE: When disposing of the front suspension bar assembly tower, see DISPOSAL. See: Disposal