Corolla CE Sedan 4-Door L4-1587cc 1.6L DOHC MFI (1997)
Power Steering Fluid: Testing and Inspection
Fluid Pressure Check
PROCEDURE
1. Connect Special Service Tool (SST).
a. Disconnect the pressure feed tube.
b. Connect SST 09640 - 10010 (09641 - 01010, 09641 - 01030, 09641 -01060) over a new gasket, as shown below.
CAUTION: Check that the valve of the SST is in the open position.
2. Bleed power steering system.
3. Boost fluid temperature.
a. Start the engine and run it at idle.
b. Turn the steering wheel from lock to lock several times to boost fluid temperature.
Fluid Temperature: 80° C (176° F).
4. Check fluid pressure reading with valve closed. With the engine idling, close the valve of the SST and observe the reading on the gauge.
Minimum Fluid pressure: 6,374 kPa (924 psi).
NOTE:
^
Do not keep the valve closed for more than 10 seconds.
^
Do not let the fluid temperature become too high.