Corolla CE Sedan 4-Door L4-1587cc 1.6L DOHC MFI (1997)
9. Connect sliding yoke.
10. Install column hole cover. Torque the 5 bolts to 4.9 Nm (43 inch lbs.).
11. Connect RH and LH tie rod ends.
12. Install RH and LH engine under covers. Tighten the 12 screws.
13. Position front wheels facing straight ahead.
NOTE: Do it with the front of the vehicle jacked up.
14. Center spiral cable.
15. Install steering wheel.
a. Align the matchmarks on the wheel and steering column main shaft.
b. Temporarily tighten the wheel set nut.
c. Connect the connector.
16. Bleed power steering system. See: Power Steering/Power Steering Bleeding/Service and Repair
17. Check steering wheel center point.
18. Torque steering wheel set nut to 34 Nm (25 ft. lbs.).
19. Install steering wheel pad.
20. Check front wheel alignment. See: Alignment