Corolla Wagon L4-107.5 1762cc 1.8L DOHC (7A-FE) (1993)
/Page-793002.png)
Fig. 2 Inner Bearing Retainer Removal.
7.
To replace axle shaft bearing, grind a groove on one side of inner bearing retainer, then using a chisel, split retainer and remove from axle shaft,
Fig. 2. Using suitable tool, press bearing from axle shaft and remove spacer (if equipped) and outer bearing retainer.
Installation
1.
Coat contact surfaces of oil seal with grease, then install oil seal in axle housing using a suitable mandrel to a depth of .220 inch.
2.
Position outer bearing retainer and spacer (if equipped) on axle shaft, then press bearing onto axle shaft.
Fig. 3 Inner Bearing Retainer Installation.
3.
Heat inner bearing retainer to approximately 302°F (150°C) in an oil bath, then press inner bearing retainer onto axle shaft with chamfered side
facing toward bearing using suitable tool, Fig. 3. When retainer is heated to 302°F (150°C), its surface will show a faint yellow color. Do not
heat retainer above this point.
4.
Install axle shaft in axle housing.
Rear Axle Carrier
1.
Remove rear axle hub as outlined.
2.
Remove brake hose from strut assembly, then backing plate from rear axle carrier.
3.
Loosen three nuts but do not remove bolts.
4.
Remove strut rod to rear axle carrier bolt and nut and disconnect strut rod from carrier.
5.
Remove three nuts, bolts and carrier.
6.
Reverse procedure to install. Tighten nuts and bolts to specifications.
