Corolla Wagon L4-96.8 1587cc 1.6L DOHC (4A-FE) (1996)
/Page-240005.png)
1. SET NO.1 CYLINDER TO TDC/COMPRESSION
-
Turn the crankshaft clockwise, and position the slit of the intake camshaft as shown in the illustration.
2. INSTALL DISTRIBUTOR
-
Install a new O-ring to the distributor housing.
-
Apply a light coat of engine oil on the O-ring.
-
Align the cutout portion of the coupling with the groove of the housing.
-
Insert the distributor, aligning the bolt hole of the flange with that of the bolt hole on the cylinder head.
-
Tighten the mounting bolt.
Torque: 20 N.m (200 kgf.cm, 14 ft.lbf)
3. CONNECT HIGH-TENSION CORDS TO DISTRIBUTOR CAP
4. CONNECT DISTRIBUTOR CONNECTOR
5. CHECK IGNITION TIMING
