Highlander 2WD L4-2.4L (2AZ-FE) (2001)
10. INSPECT BEARING BACKLASH
a. Set a dial indicator near the center of the axle hub and check the backlash in the bearing shaft direction.
Maximum: 0.05 mm (0.0020 inch)
If the backlash exceeds the maximum, replace the axle hub assembly.
11. INSPECT AXLE HUB DEVIATION
a. Using a dial indicator, check the deviation at the surface of the axle hub outside the hub bolt.
Maximum: 0.07 mm (0.0028 inch)
If the backlash exceeds the maximum, replace the axle hub assembly.
12. INSTALL REAR DISC [42431 / 98-63]
13. INSTALL REAR DISC BRAKE CALIPER ASSY, LH
a. Install the brake caliper with the 2 bolts.
Torque: 61.8 Nm (630 kgf-cm, 46 ft. lbs.)
b. Install the flexible hose with the bolt.
Torque: 29.4 Nm (300 kgf-cm, 22 ft. lbs.)
14. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
15. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
16. CHECK ABS SPEED SENSOR SIGNAL