Highlander 2WD V6-3.5L (2GR-FE) (2008)
106. INSTALL LOWER CENTER PILLAR GARNISH RH
HINT: Use the same procedure for the RH side and the LH side.
107. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH
(a) Align the alignment mark (green) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and
install the rear door opening trim weatherstrip RH.
NOTE: After installation, check that the corners fit correctly.
108. INSTALL REAR DOOR SCUFF PLATE RH
HINT: Use the same procedure for the RH side and the LH side.
109. INSTALL FRONT PILLAR GARNISH RH
(a) Remove the protective cover.
(b) Install a new clip [A] on the front pillar garnish RH.
(c) Engage the 3 guides and 2 clips, then install the front pillar garnish RH.
110. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH