Highlander 2WD V6-3.5L (2GR-FE) (2008)
(b) Install a new clip [A] on the front pillar garnish LH.
(c) Engage the 3 guides and 2 clips, then install the front pillar garnish LH.
101. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
(a) Align the alignment mark (blue) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and
install the front door opening trim weatherstrip LH.
NOTE: After installation, check that the corners fit correctly.
102. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
(a) Engage the claw and clip, install the cowl side trim sub-assembly LH.
(b) Install the clip.
103. INSTALL FRONT DOOR SCUFF PLATE LH
(a) Engage the guide and the 8 claws, and install the front door scuff plate LH.
104. INSTALL CENTER PILLAR GARNISH RH
HINT: Use the same procedure for the RH side and the LH side.
105. CONNECT FRONT SEAT OUTER BELT ASSEMBLY RH
HINT: Use the same procedure for the RH side and the LH side.