Highlander 4WD V6-3.3L (3MZ-FE) (2004)
/Page-1112004.png)
4. INSPECT REAR STABILIZER LINK ASSY LH
a. Before installing the nut, flip the ball joint stud back and forth 5 times as shown in the illustration.
b. Using a torque wrench, continuously turn the nut 3 to 5 seconds per turn, and take the torque reading on the 5th turn.
Turning torque: 1.0 Nm (10 kgf-cm, 9 inch lbs.) or less
NOTICE:
^
Check that neither unusual drag nor rattle occurs during the rotation.
^
Check that neither crack nor grease leakage exists on the dust cover.
5. REMOVE STABILIZER BAR REAR
a. Remove the 3 bolts and stabilizer bar.
6. INSTALL STABILIZER BAR REAR
a. Install the stabilizer bracket.
