Highlander 4WD V6-3.3L (3MZ-FE) (2004)
b. Install the stabilizer bar with 3 the bolts.
Torque:
Bolt A: 54 Nm (550 kgf-cm, 40 ft. lbs.)
Bolt B: 19 Nm (194 kgf-cm, 14 ft. lbs.)
7. INSTALL REAR STABILIZER LINK ASSY LH
a. Install the stabilizer link with the 2 nuts.
Torque: 39 Nm (400 kgf-cm, 29 ft. lbs.)
HINT: If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud.
8. INSTALL REAR STABILIZER LINK ASSY RH
HINT: Install the RH side using the same procedures as for the LH side.
9. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
10. INSPECT REAR WHEEL ALIGNMENT