Highlander LTD 2WD V6-3.0L (1MZ-FE) (2002)
(h) Place a new adjusting shim on the valve lifter, with imprinted numbers facing down.
(i) Press down the valve lifter with SST (A), and remove SST (B).
SST 09248-55040 (09248-05410, 09248-05420)
(j) Recheck the valve clearance.
13. INSTALL CYLINDER HEAD COVER SUB-ASSY
(a) Apply seal packing to the cylinder head as shown in the illustration.
Seal packing: Part No.08826-00080 or equivalent
NOTICE:
-
Remove any oil from the contact surface.
-
Install the cylinder head cover within 3 minutes after applying seal packing.
-
Do not start the engine within 2 hours after installing.
(b) Install the cylinder head cover with the 9 bolts. Uniformly tighten the bolts, in several passes.
Torque: 8.0 N-m (82 kgf-cm, 71 in.-lbf)
14. INSTALL CYLINDER HEAD COVER SUB-ASSY LH
(a) Apply seal packing to the cylinder head as shown in the illustration.
Seal packing: Part No.08826-00080 or equivalent
NOTICE:
-
Remove any oil from the contact surface.
-
Install the cylinder head cover within 3 minutes after applying seal packing.
-
Do not start the engine within 2 hours after installing.
(b) Install the cylinder head cover with the 9 bolts. Uniformly tighten the bolts, in several passes.
Torque: 8.0 N-m (82 kgf-cm, 71 in.-lbf)
15. INSTALL IGNITION COIL ASSY