Matrix 2WD L4-1.8L (1ZZ-FE) (2003)
/Page-963005.png)
a. Temporarily tighten the rear brake tube No.4 and flexible hose.
b. Connect the rear brake tube No.4 with the clip to the rear axle beam assy.
c. Using SST, fully tighten the rear brake tube No.4.
SST 09023-00100
Torque: 15.2 Nm (155 kgf-cm, 11 ft. lbs.)
25. CONNECT REAR BRAKE TUBE NO.3 (DRUM REAR BRAKE TYPE)
SST 09023-00100
HINT: Connect the RH side by the same procedures as the LH side.
26. INSTALL STABILIZER BAR REAR
27. CONNECT PARKING BRAKE CABLE ASSY NO.3
a. Connect the parking brake cable No.3 with the bolt.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
28. CONNECT PARKING BRAKE CABLE ASSY NO.2
a. Connect the parking brake cable No.2 with the bolt.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
29. CONNECT SKID CONTROL SENSOR WIRE (W/ ABS)
a. Connect the skid control sensor wire with the bolt and clip.
Torque: 5.0 Nm (51 kgf-cm, 44 inch lbs.)
b. Connect the skid control sensor connector.
c. Use the same manner described to the other side.
30. INSTALL REAR DISC (DISC REAR BRAKE TYPE)
HINT: Use the same manner described to the other side.
31. INSTALL REAR DISC BRAKE CALIPER ASSY LH (DISC REAR BRAKE TYPE)
32. INSTALL REAR DISC BRAKE CALIPER ASSY RH (DISC REAR BRAKE TYPE)
33. INSTALL REAR BRAKE DRUM SUB-ASSY (DRUM REAR BRAKE TYPE)
HINT: Use the same manner described to the other side.
