Matrix FWD L4-1.8L (2ZR-FE) (2010)
/Page-910051.png)
NG -- CHECK FOR SHORT TO B+ IN CAN BUS WIRE (CAN NO. 2 JUNCTION CONNECTOR - ECM)
OK -- Continue to next step.
4. CHECK FOR SHORT TO B+ IN CAN BUS WIRE (SKID CONTROL ECU BRANCH WIRE)
(a) Disconnect the skid control ECU connector.
(b) Measure the resistance according to the value(s) in the table below.
HINT
The resistance must be measured after the CAN No. 2 junction connector is disconnected.
Standard Resistance:
Result:
