Matrix FWD L4-2.4L (2AZ-FE) (2009)
Crankshaft Main Bearing: Specifications
MAIN BEARING
Step 1
Install and uniformly tighten the 10 main bearing cap bolts in the sequence shown in the illustration.
Torque.......................................................................................................................................................................................20 Nm (204 kgf-cm, 15 ft-lbf)
Retighten the 10 main bearing cap bolts in the sequence shown in the illustration.
Torque.......................................................................................................................................................................................40 Nm (408 kgf-cm, 30 ft-lbf)
Step 2
Mark the front of the bearing cap bolts with paint.
Retighten the bearing cap bolts 90° in the numerical order shown in the illustration.
Check that the paint mark is now at a 90° angle to the front.
CRANKSHAFT